Beautiful Tips About How To Clean A Single Action Revolver

Clean the chambers as you would the barrel, make sure the ejection mechanism is clean as well, and the yoke/crane and ejector rod.

How to clean a single action revolver. I would suggest that you take the cylinder out of the gun before cleaning but never remove any screws unless you want to play gunsmith. Use a patch and cleaning rod to apply the oil to the barrel and chambers. November 18, 2020 by admin 0 comments.

Cleaning the cimarron frontier model 45 long colt caliber.everyone cleans differently this is just the way i clean. Scrub under the extractor star step one, we’re going to hit the biggest problem area: On a single action revolver that will include the barrel, cylinder chambers, the back of the cylinder, and base pin.

Run some eezox down the bore with. You want to hold the firearm with your dominant hand. This would be similar to your shooting position, except your trigger finger.

Then very carefully use a brush to loosen the grime. Cleaning these areas is quick and simple. These include the back of the cylinder where the ratchet touches the frame.

Down the barrel to keep the crown in good shape. I like hoppes solvent on a bore brush. At regular intervals or when the revolver has been exposed to sand, water or other adverse conditions, disassemble, clean and oil it.

(see photo a) photo a then inside of the cylinder where it rotates on the base pin, be it a pressed in spacer (3rd gen. Up to 4% cash back next. Once you have your unloaded revolver and solvent/clp of choice, apply a tad to the barrel bore and cylinder and knock away the fouling and debris with a brush.